Advice !

[sid131]

I think its a 6202 ?
but its a high speed bearing cost should be around 20/30 quid, if its really cheap its not correct

[finnie]

A 10000 rpm should ok 😜

[Tas131]

It rarely see high revs.

[sid131]

Ok just put a cheap one in then or a secondhand one even 

[finnie]

I paid 12 quid for this 10000 rpm one  and is already put in so too late for secondhand one lol

[Tas131]

Buy what you like, it still doesn't see high revs.

[finnie]

All I need now is the timing belt tensioner but from where ? ebay is no good .
Any clue ?
Thanks

[finnie]

Update on engine thats nearly ready to go in 





Just need to change this .......



to avoid it looking like this and to get cables a bit higher as well 



And then it`s ready to go in to this old banger 

[daverwd]

very nice looking engine prep ..

[finnie]

Thanks

This really need to be moved in to the project corner ? 

[sid131]

Nice shiney rocker covers did that job cost ya 50 quid?
cool wheels

[finnie]

?50 yes but could have spend more on details but I`m quite happy with the result 

[Sev131]

Looking good Finn.

[POQ 131]

Mate, I am having trouble figuring out that cable linkage set up on the front carb. I am sitting here with a Dellorto DHLA 40 & the cable pull would have to be clockwise rotation on shaft as you look at the carb from the front of the engine.
Unless that is corrected lower on that linkage where the photo does'nt show ?
Looks like a well made job though & I am interested where to get one.
O.

[finnie]

I just bought this one

http://www.ebay.co.uk/itm/300844136899?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649