|
Title: Fiat 131 Centre bore. Post by: parrish on February 08, 2009, 02:33:31 PM Does anyone have the Centre bore dimensions for the axles of a 131?
ive been told its 58mm can someone check for me. Steve. Title: Re: Fiat 131 Centre bore. Post by: sid131 on February 08, 2009, 04:24:12 PM Hi Steve its 45mm
Title: Re: Fiat 131 Centre bore. Post by: parrish on February 08, 2009, 05:15:00 PM Seriously!
I thought it was 58mm! Title: Re: Fiat 131 Centre bore. Post by: sid131 on February 08, 2009, 06:30:30 PM Steve the pipe where the half shaft goes through is 45mm inside diameter, any other measurements you need i have cos i cut up rear axle this week, just ask.
Title: Re: Fiat 131 Centre bore. Post by: parrish on February 08, 2009, 09:14:33 PM Sorry Sid,
i was unclear in my first request. Its the centre bore for the wheel im looking for. The collar of the wheel sits around a protrusion from the axle, this locates and carries the weight of the wheel. Regards Steve Title: Re: Fiat 131 Centre bore. Post by: djape1977 on February 09, 2009, 12:15:42 AM center hole on the wheel should be 58.2mm
if bigger - get yourself some adaptors made, if smaller - get it machined to 58.2 |