|
Title: Pilot bearing Post by: longhamrob on August 07, 2013, 12:24:40 PM I intend to replace this tomorrow on my 131r. I have a new bearing purchased off ebay but am concerned it is the correct one. Has anybody got an engine out & conveniently placed where at least the diameter & internal diameter can be measured? Alternatively can anybody confirm the correct dimensions before I risk a massive waste of time.....
Title: Re: Pilot bearing Post by: david on August 07, 2013, 02:58:17 PM Rob, Do you mean the bearing in the end of the crankshaft for the geabox shaft to sit in ?
Title: Re: Pilot bearing Post by: longhamrob on August 07, 2013, 03:10:10 PM Hi David. Yes that one.
Title: Re: Pilot bearing Post by: david on August 07, 2013, 07:25:39 PM I have an engine out of the car but its up my old man's place so it won't be until friday hopefully that I will get up there is that any good ? can only measure it with a tape measure as I've lost my micrometer but that should be fine.
Title: Re: Pilot bearing Post by: Tas131 on August 07, 2013, 10:01:19 PM I've got a new bearing in it's packaging I haven't installed yet. I can measure it, but it won't be until this afternoon.
Title: Re: Pilot bearing Post by: longhamrob on August 08, 2013, 06:06:30 AM Hi Mick.
I appreciate the time difference but were you able to measure as I am starting job in a few hours. Thanks. Title: Re: Pilot bearing Post by: Tas131 on August 08, 2013, 10:37:00 AM Forgot all about it, I'll go out and do it now.
Title: Re: Pilot bearing Post by: Tas131 on August 08, 2013, 11:21:31 AM 15mm (ID) x35mm (OD) x14mm (deep)
http://www.skf.com/skf/productcatalogue/jsp/viewers/productTableViewer.jsp?lang=en&tableName=1_1_1&presentationType=3&action=&perfid=&newlink=&designationField=&searchway=1&c.2_min=15&c.2_max=16&c.4_min=35&c.4_max=36&c.7_min=14&c.7_max=15&c.32_min=&c.32_max=&c.41_min=&c.41_max=&imperial=false&impSearchValues=false Title: Re: Pilot bearing Post by: longhamrob on August 08, 2013, 12:32:22 PM Thank you for that. I did have the wrong bearing but was able to source locally. Much appreciated Mick.
|