Pilot bearing

[longhamrob]

I intend to replace this tomorrow on my 131r.  I have a new bearing purchased off ebay but am concerned it is the correct one.  Has anybody got an engine out & conveniently placed where at least the diameter & internal diameter can be measured?  Alternatively can anybody confirm the correct dimensions before I risk a massive waste of time.....   

[david]

Rob, Do you mean the bearing in the end of the crankshaft for the geabox shaft to sit in ?

[longhamrob]

Hi David.  Yes that one.

[david]

I have an engine out of the car but its up my old man's place so it won't be until friday hopefully that I will get up there is that any good ?  can only measure it with a tape measure as I've lost my micrometer but that should be fine.

[Tas131]

I've got a new bearing in it's packaging I haven't installed yet. I can measure it, but it won't be until this afternoon.

[longhamrob]

Hi Mick.
I appreciate the time difference but were you able to measure as I am starting job in a few hours. Thanks.

[Tas131]

Forgot all about it, I'll go out and do it now.

[Tas131]

15mm (ID) x35mm (OD) x14mm (deep)

http://www.skf.com/skf/productcatalogue/jsp/viewers/productTableViewer.jsp?lang=en&tableName=1_1_1&presentationType=3&action=&perfid=&newlink=&designationField=&searchway=1&c.2_min=15&c.2_max=16&c.4_min=35&c.4_max=36&c.7_min=14&c.7_max=15&c.32_min=&c.32_max=&c.41_min=&c.41_max=&imperial=false&impSearchValues=false

[longhamrob]

Thank you for that. I did have the wrong bearing but was able to source locally. Much appreciated Mick.