centre propshaft mount

[djape1977]

any rear wheel drive lada. 2101, 2102, 2103, 2104, 2105, 2106, 2107 or standard, special, riva, nova, station wagon, 1200, 1300, 1500, 1600, all have the same driveshaft.

might be different lenght to 131/132 though, but i'm pretty certain that rear section is the same for all rear wheel driven fiats and lada, while the front section varies in lenght. you can combine any two sections by connecting them on central u joint, since all use same u joints. on my lada is the front section from 132 and rear from lada. i had to combine to get lenght i needed since i used 132 gearbox which is longer than ladas.

same propshaft is on FSO 125p and polonez. later versions of polonez, post 1988 i think, have a thinner driveshaft, same u joints, centre mount and donut though.

[djape1977]

btw, i have several of those if you need it, only i'm afraid that shipping would be expensive since they're quite heavy. i believe that it should be available in poland new, if not than on scrapyards there must be some ladas left

[miro-1980]

Djape
 
Hold on to them for a while , If I cannot find them here I will ask you for one ...

Miro  

[djape1977]

sure, i don't throw away usable parts. just measure the lenght on your car so i can make the combo you need

[eugene]

Seeing that so many LADA Parts will fit Fiat,people should have much more appreciation for LADA vehicles .From what djape1977 has shown us,i think that LADA&FIAT are brothers and not cousins .Eugene

[sid131]

Sisters & brothers maby ?

[Walezy]

Lada differential has shorter length then FSO polonez or 125p(later models with "square diffs"). It is about 5cm shorter measured from the centre of differential to end of prop shaft flange. I have installed such lada differential in my FSO Polonez that i had few years ago and i remember that i had to install rear piece of Lada to fiat 132 front prop shaft piece. I am not sure right now as it was some time ago but i am almost sure i have put different length rear piece of propshaft.

[djape1977]

probably is so. fortunately, diferent lenghts of propshaft sections are available from 124, 125, 125p, 131, 132, argenta, lada, polonez, so combinations to suit all purposes are possible.

[djape1977]

and to prove that lada is no illegitimate offspring of italian automotive idustry, look what i'fe found today!

[sid131]

well no arguing with that (unless you just cast it?) lol1

[djape1977]

this manifold is 30 yrs old, but i'll definaely make a cast of it in the near future

[eugene]

Well,thats the proof .Thanks again djape .Good detective work .Well done.Eugene

[sid131]

Well Eugene thats just a little bit of evidence i will have to see some more before i decide

[theredx19]

Alquati normally stamp the car it is for in the manifold as having 2 carbs would be in the spirit of Communism as everyone else has only 1 carb but Lada are that relation you dont talk about, the relation that lives on their own and all the locals stay away from 

[brensport]

Well said red lad